Differences
This shows you the differences between two versions of the page.
pulsarinstruments:psrix2:gain_atten_ctrl [2018/12/20 14:14] ramesh |
— (current) | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== ROACH2 Signal Levelling ====== | ||
- | |||
- | The power input to the ROACH2s can be controlled by the Raspberry Pi integrated in to the gain box. A feedback on the power levels are only possible by consulting the output of the ROACH2 ADCs (either ADC histograms or the output of the PFB-FFT). This of course will only be possible if the ROACH2 FPGA is programmed appropriately, or configured with the right gateware. | ||
- | |||
- | - connect to the VNC session asterix:4 | ||
- | - load a firmware that has some ADC interfaces. eg. ''python /home/pulsar/roach2/r3xcontrol.py'' | ||
- | - start the ADC displays now: ''python /home/pulsar/roach2/r3xadchist.py'' | ||
- | - Now change the attenuator setting from another terminal: ''roach2attn <id> <atten>'', where id is 1,2,3 or 4, and attenuation is in the range of 0.5-30.5 dB in steps of 0.5. See example in the screen shot below. | ||
- | - Consult the setting on the histogram above - aim to get the signal between -50 to +50. You should see something similar to the plot in the image below. | ||
- | - For Galactic Centre magnetar observations, current settings are: 18.5/15.5/12.5/6.5 dB | ||
- | - For normal pulsar observations: 9.5/7.5/6.5/2.5 | ||
- | - Refer to the image below for an example display. | ||
- | |||
- | {{ :pulsarinstruments:gain_ctrl.png?300|}} |